Aircraft Settings:

Aircraft category:
Transponder category:
ICAO24-Address of the aircraft (as hexadecimal value):

Visit www.airframes.org to find the ICAO24-address of your aircraft.
This setting is only mandatory if your aircraft is equipped with a Mode-S transponder.



Setting FFFFFF will use default FLARM-Radio-ID.

Data Output:

Data sentences for the RJ-45 Connector:

Standard for use with Butterfly Displays is GPS and Traffic.
Suitable cables for use with Garmin devices can be found here.
Data sentences protocol for the RJ-45 Connector:

If you use a Butterfly Display, you can select Version 6; for other displays please contact the manufacturer or use the default protocol version.
Send PCAS targets to LED displays on the RJ-45 Connector:

If you use a swiss-bat v3+/v4 display, please select this option to display undirected transponder targets (PCAS).
Baudrate for the RJ-45 Connector:

Standard for use with Butterfly Displays is 19200.
Data sentences for the D-SUB 9 Connector:

Standard for use with Butterfly Displays is GPS and Traffic.
Suitable cables for use with Garmin devices can be found here.
Data sentences protocol for the D-SUB 9 Connector:

If you use a Butterfly Display, you can select Version 6; for other displays please contact the manufacturer or use the default protocol version.
Send PCAS targets to LED displays on the D-SUB 9 Connector:

If you use a swiss-bat v3+/v4 display, please select this option to display undirected transponder targets (PCAS).
Baudrate for the D-SUB 9 Connector:

Standard for use with Butterfly Displays is 19200.

Range Settings:

Range settings, especially PCAS-range, may only be changed by experts.
PCAS (Transponder) Horizontal:
PCAS (Transponder) Vertical:
ADS-B Horizontal:
ADS-B Vertical Range:
FLARM Range:
FLARM Vertical Range:

IGC Settings:

Settings for the IGC flight recorder. Parts of these settings are stored in the igc files, generated by the device. If your device does not support flight recording, these settings have no effect.
Log Interval:
Pilot Name:
CoPilot Name:
Glider ID:
Glider Type:
Competition ID:
Competition Class:
Write IGC settings only to config file (ignores the rest of the configuration above!):


Write a binary diagnostic dump-file to the USB-stick. The log is written to USB stick/SD card during startup.